Insulation Services Before & After Photos

Check out this transformation in Owings, MD 

After moving into her Tracys Landing, MD home last year, Carrie had a Home Energy Audit conducted by Complete Home Solutions to determine how energy efficient the house was. Following the Audit, our Home Comfort Specialist found several areas of the home that could be enhanced to improve on home efficiency and home comfort.  Carrie followed all of the recommendations and began to chip away at each project. Our crew began by first fully encapsulating her crawl space. They then installed a new mini-split HVAC system, and the final improvement was to properly air seal and insulate the attic. As you can see above the attic had old fiberglass batt insulation that was well below current standards to keep the home properly insulated. To fix the comfort issues our crew began by pulling back the old insulation and air sealing any recessed light covers, top plates, and cracks in the drywall then blew in a fresh layer of cellulose insulation to give this home a proper 16 inches of insulation. By air sealing it prevents any conditioned air from escaping the living space of your home, and adding insulation creates a 16in barrier between the attic temperature and the rest of your home.

Carrie's home has now been properly insulated and sealed from top to bottom. These steps will help keep her home comfortable all year round, and also help her HVAC system run less, saving money on monthly utility bills.

If you're interested in ways to make your home more efficient and comfortable, call Complete Home Solutions today to set up your Home Energy Audit at 1-410-867-1202!.

Guy called Complete Home Solutions to address the comfort problems on the second floor of his Galesville, MD home. Upon further review from one of our trained Home Comfort Specialist, it was determined that the lack of air sealing and insulation in the home's attic was a leading cause of the uncomfortable conditions. On the day of the job, our Home Comfort Technicians began air sealing the attic with fire block spray foam.  The spray foam is applied to our recessed light covers, top plates, and any outlets in the attic to ensure that the air you pay to heat or cool stays in the living space of your home. The next step in this attic was to vent the bath fans out through the roof. If your fans are not vented properly, it can create moisture issues in your attic. The final step of this attic project was to blow in new Cellulose insulation, which creates a 16 inch barrier between the attic condition and the rest of your home. As you can see in this picture, we install rulers throughout the attic to show our customers just how much of a difference our insulation makes. Nicholas noticed an immediate difference, even in mild temperatures, and can't wait to see how his house performs in the future.

This home in Annapolis Maryland was having trouble keeping rooms warm. The homeowner called Complete Home Solutions to get a home audit. Our Auditor determined that the uncomfortable temperatures were caused by insufficient insulation in the attic space.

Our Production team went in and used blow in cellulose to insulate the attic space to make the home more comfortable and more energy efficient.

The home in Annapolis, MD was suffering from cold floors in their sun room and called Complete Home Solutions. Our Auditor was sent to determine the source of the uncomfortable temperatures. It was determined that the source was insufficient insulation under the sun room.

Our Production Team was sent to use spray foam to insulate the bottom of the sun room to make the temperatures more comfortable.